Welcome Guest | RSS
Welcome to science club
Site search
Site menu
Indian Heritage
Social bookmarks
Home » 2014 » October » 10 » Satellites
10:44 AM
Satellites

How Do Satellites Work?



Satellite Communication Basics
The basic elements of a satellite communications system are shown in Figure 1 below. The process begins at an earth station--an installation designed to transmit and receive signals from a satellite in orbit around the earth. Earth stations send information in the form of high powered, high frequency (GHz range) signals to satellites which receive and retransmit the signals back to earth where they are received by other earth stations in the coverage area of the satellite. The area which receives a signal of useful strength from the satellite is known as the satellite's footprint. The transmission system from the earth station to the satellite is called the uplink, and the system from the satellite to the earth station is called the downlink.

 

 

Figure 1: Satellite Communication Basics

 

Satellite Frequency Bands
The three most commonly used satellite frequency bands are the C-band, Ku-band, and Ka-band. C-band and Ku-band are the two most common frequency spectrums used by today's satellites. To help understand the relationship between antenna diameter and transmission frequency, it is important to note that there is an inverse relationship between frequency and wavelength--when frequency increases, wavelength decreases. As wavelength increases, larger antennas (satellite dishes) are necessary to gather the signal.

C-band satellite transmissions occupy the 4 to 8 GHz frequency range. These relatively low frequencies translate to larger wavelengths than Ku-band or Ka-band. These larger wavelengths of the C-band mean that a larger satellite antenna is required to gather the minimum signal strength, and therefore the minimum size of an average C-band antenna is approximately 2-3 meters in diameter as shown in Figure 2.

 

 

Figure 2: C-band Satellite Antenna

 

Ku-band satellite transmissions occupy the 11 to 17 GHz frequency range. These relatively high frequency transmissions correspond to shorter wavelengths and therefore a smaller antenna can be used to receive the minimum signal strength. Ku-band antennas can be as small as 18 inches in diameter, as commonly seen in the RCA DSS and Sony DSS systems. Figure 3 below shows the Ku-band antenna of the Sony DSS system.

 

 

Figure 3: Ku-band Satellite Antenna

 

Ka-band satellite transmissions occupy the 20 to 30 GHz frequency range. These very high frequency transmissions mean very small wavelengths and very small diameter receiving antennas.

Geosynchronous Earth Orbit (GEO) Satellites
Today, the overwhelming majority of satellites in orbit around the earth are positioned at a point 22,238 miles above the earth's equator in a special type of geosynchronous earth orbit (GSO) known as Geostationary earth orbit (GEO), or what is sometimes called Clarke orbit. This is in honor of 
Arthur C. Clarke, the man who first suggested in 1945 that satellites in geosynchronous orbits could be used for communications purposes. As shown in Figure 4, it is at the precise distance of 22,238 miles that a satellite can maintain an orbit with a period of rotation around the earth exactly equal to 24 hours. Since the satellites revolve at the same rotational speed of the earth, they appear stationary from the earth’s surface. That's why most earth station antennas (satellite dishes) don't need to move once they have been properly aimed at a target satellite in the sky. The mathematical derivation of the Clarke orbit is a straight-forward calculus problem.

 

 

Figure 4: The Clarke Orbit

 

Medium Earth Orbit (MEO) Satellites
During the last few years, technological innovations in space communications have given rise to new orbits and totally new systems designs. Medium earth orbit (MEO) satellite networks have been proposed that will orbit at distances of about 8000 miles. Signals transmitted from a MEO satellite travel a shorter distance which translates to improved signal strength at the receiving end. This means that smaller, more lightweight receiving terminals can be used. Also, since the signal is traveling a shorter distance to and from the satellite, there is less transmission delay. Transmission delay is the time it takes for a signal to travel up to a satellite and back down to a receiving station. For real-time communications, the shorter the transmission delay the better. For example, a GEO satellite requires .25 seconds for a round trip. A MEO satellite requires less than .1 seconds to complete the job. MEOs operate in the 2 GHz and above frequency range.

Low Earth Orbit (LEO) Satellites
Proposed LEO satellites are divided into three categories: little LEOs, big LEOs, and Mega-LEOs. LEOs will orbit at a distance of only 500 to 1000 miles above the earth. This relatively short distance reduces transmission delay to only .05 seconds and further reduces the need for sensitive and bulky receiving equipment. Little LEOs will will operate in the 800 MHz (.8 GHz) range, big LEOs will operate in the 2 GHz or above range, and Mega-LEOs will operate in the 20-30 GHz range. The higher frequencies associated with Mega-LEOs translates into more information carrying capacity and the capability of real-time, low delay video transmission.
Microsoft Corporation and McCaw Cellular (now known as AT&T Wireless Services) have partnered to deploy 840 satellites to form Teledesic, a proposed Mega-LEO satellite network.

High Altitude Long Endurance (HALE) Platforms
Experimental HALE platforms are essentially highly efficient and lightweight airplanes carrying communications equipment that will act as very low earth orbit geosynchronous satellites. These crafts will be powered by high efficiency turbine engines or a combination of battery and solar power. At an altitude of only 70,000 feet, HALE platforms will offer transmission delays of less than .001 seconds and even better signal strength for very lightweight hand-held receiving devices.
(2)

Orbital Slots
With more than 200 satellites up there in geosynchronous orbit, how do we keep them from running into each other or from attempting to use the same location in space? To tackle that problem, international regulatory bodies like the 
International Telecommunications Union (ITU) and national government organizations like the Federal Communications Commission (FCC) designate the locations on the geosynchronous orbit where communications satellites can be located. These locations are specified in degrees of longitude and are known as orbital slots. In response to the huge demand for orbital slots, the FCC and ITU have progressively reduced the required spacing down to only 2 degrees for C-band and Ku-band satellites.

More about satellite studies click below:

Satellite studies

Views: 959 | Added by: scienceclub | Rating: 0.0/0
Total comments: 0
avatar
Live feeds update
Country
Flag Counter
Visitors
www.scienceclub.ucoz.com
scienceclub.ucoz.com
This Website Visits
Site news
Calendar
«  October 2014  »
SuMoTuWeThFrSa
   1234
567891011
12131415161718
19202122232425
262728293031
Google +